Skip to content

We'll ring you back

Leave your number and a time that suits you: we'll call to talk through your project or a light.

We only use your number to call you back. See our privacy policy.

Basket

Your basket is empty

Article: How to Light a Living Room Without a Ceiling Light

A pale blue Georgian sitting room with a white marble fireplace, a gilt landscape and two black cordless mushroom lamps lit on the mantelpiece, daylight

How to Light a Living Room Without a Ceiling Light

If your sitting room has no overhead lighting, or a ceiling point nobody uses, you can still light it well. The living room lighting ideas that work here need no new wiring: lamps at three heights around the room, cordless lamps where there is no socket, a battery picture light, and a plan built around where your sockets are. Done this way, a room without a ceiling light can feel warmer than one lit from the middle.

What you gain, and what to plan for

Light that comes only from overhead flattens a room and leaves its corners dim. Lamps do the opposite: they put light at seated height and into the corners, which is where you want it in the evening.

Two things need planning instead. First, there is no switch by the door, so you need a way to bring light on as you walk in. Second, lamps are softer than a ceiling light, so you need enough of them, spread round the room, for the times you want to see properly: tidying, looking for your glasses, a jigsaw on the coffee table.

Lamps at three heights

Light coming from one level, however many lamps you have, looks flat in its own way. Spread it over three heights:

Height Where Its job From our range
Low Side tables beside the sofa and chairs A glow at seated height, close to you Holt (21 cm), Alnwick (37.5 cm)
Middle Console, sideboard, bookcase, windowsill Light across the room, seen from the door Burford Large (33 cm), Cley on a bottle
High The wall above a painting or mirror Lifts light up the wall, gives the room a focal point Moreton (68 to 128 cm)

For reading, add a shaded lamp by the chair, placed to one side of you or a little behind. How tall a lamp should be next to a sofa is covered in table lamp and bedside lamp heights.

Cordless lamps: light where there is no socket

Cordless lamps solve the corner with no socket, the middle of a coffee table, the deep sill of a sash window. They run on a battery you recharge, and ours dim with a touch.

  • Alnwick stands 37.5 cm tall in solid wood, pale or deeper in tone. One brush of the fingers switches it on, off and sets the brightness. It charges over USB-C, with the cable in the box, and is made for indoor use only.
  • Holt is smaller, 21 cm, with a rounded gloss metal shade in seven colours and a 6 W LED. A fingertip on the crown of the shade lights it and changes the brightness, and one of its three colour settings is a 3,000 K warm white for the evening. It charges over USB-C too.
  • Cley sits on the neck of an empty wine bottle (not supplied). It gives 6 to 8 hours on a charge, depending on brightness, which goes from 5 to 100%.

Be realistic about two things. These are glow lamps rather than reading lamps: Cley's page calls it a mood light. And Alnwick's page gives a 1,100 mAh battery and Holt's a 1,500 mAh one, but neither gives the hours, so if runtime matters to you, ask us before you order. Charge them with the cable supplied and a good-quality USB plug, on a hard, dry surface, as our fitting guide sets out. Our guide to cordless table lamps goes into the rest.

The high layer: a battery picture light

The high layer is the hardest to reach without an electrician, because wall lights need a wall light point. A battery picture light gets round that.

Moreton is a slim rechargeable bar of light that fixes above a painting or a mirror, in a sitting room or a hall. It comes in 68, 98 or 128 cm, giving about 1,320, 1,980 or 2,640 lumens; for comparison, the old 100 W bulb gave about 1,521. It switches on at a touch, and the same fingertip sets how bright it is. It recharges over USB, then runs for up to 4 hours, and fixes with screws or, if you would rather not drill, adhesive.

Other ways to get light onto a wall without new cables are in wall lights without wiring.

Plug-in lamps, and where your sockets are

Before you buy a single lamp, draw the room on a sheet of paper and mark every socket. Then mark where you sit. The plan almost draws itself: a lamp near each seat, one on the surface you see from the door, and something for the darkest corner.

Check each lamp's lead against the distance to its socket. Burford, with its ribbed cognac-tinted globe over a walnut-stained carved wooden foot, has a 150 cm lead with a switch part-way along. Its sealed LED gives 3,000 K warm white, and the Large, 33 cm tall, suits a console or sideboard. Run leads along the wall or behind furniture, never across a path through the room.

Where sockets are short, resist the chain of adaptors. Electrical Safety First's advice on extension leads and adaptors is clear: never plug one extension lead into another, and if you rely on them every day, consider having more wall sockets fitted by a registered electrician.

Getting light as you walk in

With no switch by the door, the first lamp you reach matters most. Put a lamp with an easy switch on the surface nearest the door: a touch lamp like Alnwick or Holt, or a lamp whose switch sits on its lead within reach. Light that one first, then the others as you settle. If you find you never bother with the far lamps, that is a sign they are in the wrong place or too hard to switch on.

If you rent

Most of this plan leaves no mark. Lamps and cordless lamps go with you when you move, and Moreton can go up with adhesive instead of screws. Check your tenancy agreement before you drill or fix anything to a wall, and ask your landlord before changing a fitted light.

A ceiling point you don't use

Some rooms have a ceiling point with a bare bulb or a harsh fitting that nobody switches on. You can leave it as the light for cleaning and lost earrings, and let the lamps take the evenings. Or replace it with something softer on a dimmer, and it becomes the ambient layer the lamps build on. Our living room lighting ideas show how the two work together.

A quick checklist

  • Every socket marked on a sketch of the room.
  • A lamp near each seat, at three different heights round the room.
  • One easy switch, or a touch lamp, nearest the door.
  • Lead lengths checked against socket distances.
  • One colour of white for every lamp, around 2,700 K, or 3,000 K if one lamp is fixed there.

Our table and desk lamps are a good place to start. For every room in the house, with the numbers that matter, have a look at our free Room-by-Room Lighting Guide.

Read more

A bottle-green Georgian dining room with a triple travertine pendant lit over a mahogany dining table, two sash windows at blue hour
Room by Room

Dining Room Lighting Ideas, From Round Tables to Long Ones

Light the table, the walls and the sideboard, not just the middle of the ceiling. How to size a light for a round or a long table, cope with a low ceiling, and dim it all for dinner.

Read more
The corner of a Georgian sitting room in deep plum-red with a dusty-rose velvet sofa and a lit amber glass table lamp on a mahogany side table, sash window at blue hour
Room by Room

Layered Lighting Explained: Ambient, Task and Accent

Three layers of light, each with its own job and its own switch. A clear definition of ambient, task and accent lighting, with examples in a sitting room, a study and a bedroom.

Read more