Skip to content

We'll ring you back

Leave your number and a time that suits you: we'll call to talk through your project or a light.

We only use your number to call you back. See our privacy policy.

Basket

Your basket is empty

Article: How High Should a Pendant Light Hang Above a Dining Table?

A Georgian dining room in deep plum-red with a ribbed pale wood dome pendant lit over a round mahogany table, sash window at blue hour

How High Should a Pendant Light Hang Above a Dining Table?

The right pendant light height above a dining table is 60–90 cm (24–35 in), measured from the table top to the bottom of the light. Most guides settle on the upper part of that range, 75–90 cm, where the light falls on the table and you can still see the person sitting opposite. Your ceiling height doesn't change that number. It only changes how long the drop has to be.

Why the table sets the height, not the ceiling

A light over a dining table has two jobs. It lights what is on the table, and it lets everyone sitting round it see each other. Hang it too high and the light spreads into the room while the table stays dim. Hang it too low and it sits between you and your guests. Neither has anything to do with the ceiling, so a pendant 80 cm above a table looks the same in a 1930s semi as it does in a tall Victorian dining room. The only difference is the length of flex above it.

This is also why the usual headroom rule doesn't apply here. Anywhere people walk, a hanging light needs at least 2.1 m (about 6 ft 11 in) clear beneath it. Nobody walks across the dining table, so a pendant can hang much lower over it. Keep it centred over the table, though, and if the table ever moves, raise or move the light with it.

How far down from the ceiling is that?

You need three numbers: your ceiling height, your table height and the gap you want. Our example uses a table 75 cm high, but tables vary, so measure yours. With the bottom of the light 75–90 cm above that table, it ends up 1.50–1.65 m from the floor, whatever the ceiling. The table below turns that into a drop from the ceiling.

Ceiling height Ceiling to the bottom of the light Worth checking
2.3 m (about 7 ft 7 in) 65–80 cm Some hanging lights ask for a taller ceiling: read the product page
2.4 m (about 7 ft 10 in) 75–90 cm The minimum ceiling for Kendal and for the hanging Eton
2.7 m (about 8 ft 10 in) 1.05–1.20 m Measure the flex, allowing for the height of the shade
3.0 m (about 9 ft 10 in) 1.35–1.50 m Check the flex or cable length before you order
3.2 m (about 10 ft 6 in) 1.55–1.70 m The tall-ceiling example in our guide

The drop is measured to the bottom of the light, so it includes the light itself. To know how much flex or cable you need, take off the height of the shade. The large Eton stands 27 cm tall, for example, and a Kendal disc 13 cm.

How wide should a dining table pendant be?

Choose a light between half and two-thirds of the table's width. That keeps it in proportion with the table rather than with the room.

  • 80 cm wide table: a light 40–53 cm across
  • 90 cm wide table: 45–60 cm
  • 100 cm wide table: 50–67 cm
  • 120 cm round table: 60–80 cm

Small shades work differently. Rye, a ribbed ceramic pendant painted by hand, has a shade 18 cm across: on its own it would look lost over a family table, but two or three in a row over a longer one read as a set. If you are sizing a central light for the room rather than for the table, the rule is different, and our guide to what size ceiling light your room needs works it through.

Round, square or long: one pendant or several?

Round and square tables

One pendant, centred on the table rather than on the room. If your ceiling point sits in the middle of the room and the table doesn't, see the quick questions below before you buy.

Long tables

For a table of 160–200 cm, use two or three pendants, or one linear light. To place several pendants, divide the length of the table into equal parts and hang one light over the centre of each part, all at the same height. On a 180 cm table:

  • two pendants sit 45 cm in from each end, 90 cm apart;
  • three pendants sit 30 cm in from each end, 60 cm apart.

Eton is a good candidate for a pair or a trio. Its tiered opal glass carries the light across its whole surface, so it lights evenly and never dazzles, and it comes in Ø 20 or Ø 30 cm. The hanging version is meant for a ceiling of at least 2.4 m.

Linear lights

A bar, or a row of heads on one fitting, lights a long table from end to end from a single ceiling point. Choose one a little shorter than the table.

  • Masham is a wooden bar in 80, 100, 120 or 150 cm, with a 3,000 K warm white LED behind an opal panel. Each of its two cables adjusts up to 150 cm.
  • Kendal also comes as a triple: three travertine discs lined up over 80 or 100 cm. Its product page gives the same advice, a length slightly shorter than the furniture below.
  • Woodbridge carries two aluminium shades on a 102 cm bar hung from one ceiling point, and looks best over a surface a little longer than itself. Its height is set with suspension rods rather than a flex.

You will find more shapes and sizes among our kitchen and dining lights.

Under a tall Victorian or Edwardian ceiling

Tall rooms catch people out because the drop gets long. With a 3.2 m ceiling and a table about 75 cm high, the bottom of the light should sit roughly 1.5–1.7 m below the ceiling. Not every pendant has that much flex, so check the length on the product page before you order. Rye's flex adjusts up to 180 cm, while Kendal's cable and each of Masham's two cables are 150 cm.

A long drop also leaves a lot of dark space above the table in the evening. Wall lights and a lamp on the sideboard fill it, and our article on lighting a high-ceilinged room goes through the rest of the room.

Try it before anything is fixed

Ten minutes with string and a cardboard box will tell you more than any photograph.

  1. Measure the table: its height, its width and length, and where its centre falls on the ceiling.
  2. Cut a circle of card the width you have in mind, or find a box of a similar size, and hang it on string over the centre of the table.
  3. Set it 75 cm above the table, then 90 cm. Each time, sit in your usual chair and look at the person opposite.
  4. Stand in the doorway and look again. The light should line up with the table, not with the room.
  5. Once you have your height, measure from the ceiling to the bottom of the card and write it down. Whoever fits the light can mark that point on the flex with masking tape before anything is cut.

Quick questions

Is the height the same for a chandelier?

Yes. Measure from the table to the lowest point of the chandelier and keep to the same 60–90 cm. A chandelier with several tiers is tall in itself, so allow for its full height when you work out the drop.

What if the ceiling point isn't above the table?

You can move the table, or have the light point moved. In England, altering an existing lighting circuit is not notifiable building work unless it is in the space around a bath or shower, but it must still be done to the wiring standard, BS 7671. Wales has its own rules: there, adding or moving a light point in a kitchen is notifiable work, which can matter in a kitchen-diner. An electrician can do this for you if you prefer, and our fitting guide explains what is involved.

Is an island any different?

Slightly: over a worktop, the bottom of each shade sits 70–90 cm above the surface. Our guide to pendant lights over a kitchen island covers the height, the spacing and how many to choose. For the rest of the dining room, from wall lights to dimming, see our dining room lighting ideas.

The dining-table numbers sit on the one-page cheat sheet of The Room-by-Room Lighting Guide, our free guide, next to the ones for islands, wall lights and headroom. Take it to the table with a tape measure, and you will have your drop before you choose the light.

Read more

A heritage kitchen with navy cabinetry, cream walls and a marble island under two lit opal schoolhouse pendants, sash window at blue hour
Sizes & Heights

Pendant Lights Over a Kitchen Island: Height, Spacing and How Many

Island pendants sit 70–90 cm above the worktop and about 60–75 cm apart. Here is how many to hang over a 1.8, 2, 2.4 or 3 m island, and when one linear light is simpler.

Read more