Passer au contenu

On vous rappelle

Laissez votre numéro et le moment qui vous arrange : nous vous appelons pour parler de votre projet ou d'un luminaire.

Votre numéro sert uniquement à vous rappeler. Voir notre politique de confidentialité.

Panier

Votre panier est vide

Article : Open-Plan Kitchen-Diner Lighting: How to Zone the Space

An oxblood Georgian dining room with a slim oak linear pendant lit over a long mahogany table laid for dinner, two sash windows at blue hour

Open-Plan Kitchen-Diner Lighting: How to Zone the Space

The open-plan lighting ideas that work best treat one big room as several small ones: a kitchen zone, a dining zone and often a sitting zone, each with its own lights on its own switch. Keep a single colour of white across the whole space, about 3,000 K, so the zones still read as one room when everything is on.

Get those two things right and the same room can be bright for cooking at six and soft for supper at eight.

How do you zone an open-plan kitchen-diner with light?

Start with a sketch of the room from above. Mark where you cook, where you eat and where you sit, and the doors you come in by. Each of those areas is a zone, and each one needs light of its own: stronger over the worktops, lower and gentler over the table, soft and mostly at eye level around the sofa.

The sight-loss charity Thomas Pocklington Trust puts the principle simply in its guide to home lighting: for the most control, each lighting element should be controlled separately, by its own switch or dimmer. In an open-plan room that matters even more, because one switch for every light means the kitchen is either a workshop or dark.

Zone Its job Lights that suit it Key number
Kitchen Cooking, washing up Ceiling lights, lights under the wall cupboards About 3,000 K
Island Prep, breakfast Pendants or a linear light Bottom of each shade 70–90 cm (28–35 in) over the worktop
Table Meals, homework One pendant, two or three in a row, or a linear light 60–90 cm (24–35 in) from table top to light
Sitting area Evenings Wall lights, table lamps Wall lights 1.5–1.8 m from the floor
Walkways Getting through safely Anything hanging must clear heads Headroom of 2.1 m (6 ft 11 in) minimum

Separate switches or separate circuits?

What you need is separate control. That usually means separate switches, or a switch plate with several gangs, one per zone. It does not always mean new circuits, and the difference matters.

In England, a brand-new circuit from the consumer unit is notifiable work: a registered electrician certifies it, or you tell building control before work starts. Extra lights or switches on a circuit you already have are not notifiable there, except within the zones around a bath or shower. Wales draws the line at the kitchen: adding a light point in a kitchen has to be notified. The Welsh Approved Document P defines a kitchen as a room, or part of a room, containing a sink and food preparation facilities, and suggests, as a guide only, that in an open-plan area the kitchen zone runs 3 m out from the edge of the sink, or to a nearer dividing wall. If you are unsure where your kitchen zone ends, ask building control before you start. Scotland and Northern Ireland have separate building regulations, and wherever you live the work must meet BS 7671.

If you are building an extension, this is the moment to plan switching, because the walls and ceilings are open. Put the switches where you walk in, and if the room has two entrances, ask for the main lights to work from both. An electrician can design and fit all of this for you; our fitting guide explains what to check if you are swapping a light yourself.

Why one colour of white matters so much here

In a separate kitchen, a slightly cooler bulb goes unnoticed. In an open-plan room you see every light at once, and a bluish kitchen next to a golden dining table looks like two different houses. Our guide suggests about 3,000 K for kitchens and about 2,700 K for dining rooms, but it also says one colour temperature per room. An open-plan space is one room, so choose one.

For a space where cooking is the daily work, 3,000 K across the board is a sound choice, and you can make the evening softer with dimmers and by switching zones off, rather than with a warmer bulb. Check the kelvin figure on every light you buy, and on every replacement bulb. If you are torn between the two, our guide to 2,700 K and 3,000 K explains the difference.

Lighting a long table: linear lights and rows of pendants

A single round pendant over a long table leaves both ends in shade. Once the table reaches about 160 to 200 cm, use two or three smaller pendants spaced along it, or one linear light. Hang it so its lowest edge is 60 to 90 cm over the top: low enough to light the plates, high enough that nobody has to peer round it to talk.

For a linear light, look at Masham. Its LED runs the length of a wooden bar and shines down at 3,000 K, softened on the way by an opal acrylic panel. The bar is made in 80, 100, 120 and 150 cm lengths, each in a pale or a dark wood, and it hangs on two cables of up to 150 cm, so you decide the drop. Pick a length shorter than the table, so a little of the table top shows beyond each end of the bar.

If you would rather keep to one ceiling point, Woodbridge hangs a pair of aluminium shades from a single 102 cm metal bar. Its height is set during fitting, using three suspension rods. Its page asks you to measure the surface first, because the bar suits a top slightly longer than its own 102 cm, an island for instance.

Round tables and other shapes are covered in our dining-table pendant height guide.

Do the sum before you order

The drop you need is the ceiling height, minus the table height, minus the gap you want above the table. In a kitchen-diner with a 2.7 m ceiling and a 75 cm table, aiming for 80 cm above the top: 2.70 − 0.75 − 0.80 = 1.15 m, so the light should finish 1.15 m below the ceiling. Compare that with the cable or rod length on the product page before you buy.

Rear extensions, rooflights and walls of glass

If your kitchen-diner sits in a rear extension, with rooflights, bifold doors or a sloping ceiling, three things change.

The slope. Not every pendant can hang from a pitched ceiling. Southwold, a very slim paper disc that glows evenly across its whole surface, can hang from a ceiling sloping up to 30°, on a 150 cm adjustable cord. It comes from 40 to 100 cm across, and you choose warm white 3,000 K, neutral or cool when you order: take the 3,000 K to match the rest of the room. Its brightness cannot be dimmed, so give it its own switch. Coniston, a wide, low shade of layered white fabric, also has a mount that makes up for a pitch of up to 30°, and its height adjusts over 150 cm.

The glass. After dark, a wall of glass behaves like a dark mirror and shows every light in the room a second time. Bare bulbs double their glare. Diffused, shaded lights such as a paper disc or a fabric shade reflect as a soft shape instead of a bright point.

The height. A tall extension tempts you to hang lights high. Over the table, measure from the table, not the ceiling. Over a walkway, keep at least 2.1 m clear underneath.

Setting up evening scenes

A scene is simply a combination of lights you use together. With separate switches, three cover most evenings:

  • Cooking: kitchen ceiling lights and the lights under the cupboards on, the table light on low.
  • Supper: table light on, kitchen lights off except one low light near the hob or sink, sofa lamps on.
  • Late evening: lamps and wall lights in the sitting zone only, with a glow left near the kitchen so you can find the kettle.

The Pocklington guide warns against deep shadows and sharp changes in light levels within a room. In practice, never let one zone go fully dark while another is bright, or your eyes have to adjust every time you cross the room.

If you want to dim, check three things: the bulb says dimmable, the dimmer is made for LEDs (usually trailing-edge), and the total wattage on it sits within the dimmer's LED range. Where the LED is built in, its product page says whether that light dims at all (Southwold, for instance, doesn't). Our guide to dimming LED lights without flicker covers the details.

A worked example: the back of a 1930s semi

Picture a rear extension 6 m wide and 4 m deep. The kitchen runs along the party wall, there is a 180 cm table under the rooflight, and a small sofa faces the garden doors.

  1. Kitchen: two flush ceiling lights along the worktop run, plus lights under the wall cupboards, on one switch by the hall door.
  2. Table: one linear pendant or a row of three, bottom 60–90 cm above the table, on its own dimmer.
  3. Sofa end: a pair of wall lights at 1.5–1.8 m, or table lamps from sockets, on a third switch.
  4. Colour: every light and bulb at 3,000 K.
  5. Doors: the kitchen and table lights switchable from the garden doors too.

Browse our kitchen and dining lights zone by zone, and for the kitchen end in more detail, read our practical kitchen lighting plan. Every height and colour figure used here is in our free Room-by-Room Lighting Guide.

Read more

A bottle-green panelled Georgian bedroom with two opal globe wall lights lit either side of an upholstered bed, sash window at blue hour
Room by Room

Bedroom Lighting Ideas for Restful Evenings

A bedroom needs little light, but the right light: a ceiling light you can't see from the pillow, warm white at about 2,700 K, and small lights for the mirror, the wardrobe and the night.

Lire la suite
A heritage kitchen with bottle-green walls and an oak dresser of blue-and-white china, three hand-painted ceramic pendants lit over a scrubbed oak table, sash window at blue hour
Room by Room

Kitchen Lighting Ideas: A Practical Plan

A practical plan for kitchen lighting: an even light for the room, a stronger one on the worktops, sink and hob, and a softer one over the table, all at about 3,000 K.

Lire la suite