
Bedside Wall Lights: Height, Reach and Switches
There is no single correct height for bedside wall lights, because beds, mattresses and headboards all differ. The reliable method is a trial run before anything is fixed: read in bed as you normally would while a second person holds the light beside you and moves it until the book is well lit and the bulb stays out of view, then mark the wall there. Then check how far the arm reaches, and put the switch where your hand falls.
That takes ten minutes, and it saves you from a light that dazzles you every night for years.
Why bedside wall light height has no standard number
Elsewhere in the house, wall lights normally go 1.5 to 1.8 m above the floor, roughly at eye height, which keeps a bright bulb out of your line of sight as you walk past or sit on the sofa. In bed you are lower, leaning back, and your eyes move between the page, the ceiling and the pillow. A divan with a deep mattress sits you noticeably higher than a low wooden bed, and a tall upholstered headboard pushes the light up again.
The Thomas Pocklington Trust's good-practice guide on home lighting makes the point that matters: a bedside light should be placed so it doesn't cause glare whether you are sitting up or lying down. That is a position, not a number, and only you, in your bed, can find it.
The book test, step by step
- Make the bed as you normally have it, with the pillows you read against.
- Sit up and hold a book exactly where you usually hold it.
- Ask someone to hold the light, or a torch in its place, against the wall beside you. Move it up, down, forwards and back until the page is evenly lit and you cannot see the bulb.
- Now lie down flat and look up. If the bulb glares at you, move the light higher or further back, and check the page again.
- Mark the wall with masking tape where the centre of the backplate goes.
- Measure from the wall to the middle of your book. That is the reach you need.
- Repeat on the other side for the other person.
Do the test before anything is fixed. A light that has not been fitted can still go back in its original box under our 30-day returns.
Four bedside wall lights compared
| Light | Shape | Size or reach | Cap | Dims? | By the bed |
|---|---|---|---|---|---|
| Winchcombe | Jointed arm that folds back to the wall | Up to 70 cm from the wall (58 cm with the slimmer shade) | GU10, bulb supplied | No | A beam aimed down at the page; pick the warm white version |
| Orford | Smooth ball of glass at the tip of a slim rod | 60 × 18 cm; ball 15 cm | E14, bulb supplied | No | A glow; the tinted globes give a gentler one |
| Amberley | Tube of glass standing off the wall | Tube 48 cm long, 10 cm wide | GU10, bulb supplied | Not stated | A warm glow from a tube you aim up or down |
| Kersey | Milky globe set inside a drop-shaped frame | 37 × 12 cm | G9 (7 W max.), bulb supplied | Not stated | A gentle wash on the wall above and below it |
Reading light for bed: how far should the arm reach?
If you read in bed most nights, a swing arm is the most useful thing on the wall. It frees up the bedside table, brings the light to the page and folds away afterwards.
Winchcombe is a reading light on a jointed arm that extends, then folds back against the wall. It has four adjustments: the mount turns 180° on the wall, the arm folds to 90°, the elbow turns 180° and the shade 350°. Its page gives a simple rule. If the distance from the wall to your book is up to 58 cm, the slimmer cylinder shade is enough; any further, take the cone, which reaches 70 cm. It comes in matt black or satin gold, with a GU10 LED bulb in warm or cool white. It isn't dimmable, so for a bedroom choose the warm white.
Its light points downwards, which helps in a shared bed: the beam stays on your page rather than spreading across the other pillow.
Bedside lights for a glow rather than a beam
Not everyone reads in bed. If you want a soft light to wind down by, find a book on the bedside table or get up in the night, a glowing wall light is calmer than a spotlight. Shade the bulb, so nobody is dazzled lying down.
Kersey holds an opal glass globe inside a drop-shaped metal frame, in matt black or gold. The milky glass diffuses the glow of its G9 bulb rather than showing it, and it lights the wall gently, upwards and downwards. Plan two, one each side.
Orford sets a 15 cm glass globe at the tip of a slender iron stem, 60 cm tall. Clear glass lets the most light through, while amber and smoke grey filter it more, so by a bed the tinted globes are the gentler choice. Its E14 LED works from the wall switch and cannot be dimmed.
Amberley is a 48 cm glass tube with a warm white GU10 LED inside, and the tube can point up or down as you like. Clear glass lets the light out as it is, frosted or opal white glass softens it, and the tinted versions colour it.
Bedroom wall lights with a switch you can reach
Even a well-placed bedside light is annoying if you have to get out of bed to turn it off. Before you choose, decide how each light will be switched.
Winchcombe and Orford, for example, are switched from the wall switch on their circuit, and the product pages of Kersey and Amberley don't mention a switch on the light itself. So the question is where that wall switch goes. You have three options:
- A switch by the bed. Put it where your hand falls when you are sitting up, so you can reach it without twisting. One per side.
- Two-way switching for the main light. The Pocklington guide suggests two-way switches at key places, so the ceiling light works from the door and from the bed.
- A lamp with its own touch control on the bedside table, which needs no wiring at all (see below).
Moving or adding a switch is electrical work. In England it isn't notifiable if it is an alteration to an existing circuit away from a bath or shower, and in Wales it isn't either outside a kitchen, bathroom or outdoors. It must still meet the wiring standard, BS 7671. An electrician can do this for you if you prefer. Each wall light also needs a wall light point at the spot you choose. Where there isn't one, creating it is a bigger job than a swap, and our fitting guide explains when we would suggest an electrician.
Two sides of a double bed
Do the book test for each person. If the two marks come out within a few centimetres of each other, split the difference so the pair hangs level. If they are far apart, a swing arm solves it, because each of you can bring the shade to your own page.
Centre each light on its side in the same way, for example the same distance from the edge of the headboard, so the pair looks deliberate. Give each side its own switch, and choose lights that point down rather than glare outwards, so one of you can read while the other sleeps. How far apart to set a pair, and how to keep it symmetrical, is covered in our guide to pairs of wall lights.
The cordless option: no wiring, no switch to move
If there is no wall light point by the bed, or you rent, a cordless lamp on the bedside table does much of the job. Holt is a small 21 cm rechargeable lamp: a fingertip on the crown of the shade turns it on and off and brings the brightness up or down, and one of its three settings is a 3,000 K warm white, gentle for the evening. It charges over USB-C and runs without a cable once charged. Charge it on a hard, dry surface and unplug it when it's full.
A table lamp has its own height rules, which we cover in bedside lamp heights. For more on battery lamps, read what to know before you buy a cordless lamp.
Quick questions
Can I use any wall light as a reading light?
Only if it puts enough light on the page without showing you the bulb. A globe that glows evenly is lovely for winding down, but a directed shade on an arm is far better for reading a novel.
Should both bedside lights match the ceiling light's colour?
Yes. Keep one colour temperature in the room, or the pair will look yellow next to a whiter ceiling light, or the other way round. Our guide suggests about 2,700 K for a bedroom; if one light you love only comes in 3,000 K, match the others to it rather than mixing. Our bedroom lighting ideas explain how to light the rest of the room.
Browse our bedroom lights once you have your measurements. The bedroom page of The Room-by-Room Lighting Guide, free to download, has the book test on one sheet to keep by the bed.


















