
Hallway Lighting Ideas for Narrow British Halls
The simplest hallway lighting ideas are often the best: one ceiling light just inside the front door, a second further along a long hall, and slim wall lights in between where a pendant would steal headroom. Keep the light even, so walking from the hall into the sitting room never feels like stepping out of a cave.
In a long, narrow hall, the order in which you place those lights matters more than the lights themselves. Walk through it with us, from the doormat to the stairs.
Start at the front door
Thomas Pocklington Trust, a charity for people with sight loss, publishes a lighting guide for existing homes, and it puts the first light on the ceiling just inside the front door. From there it lights the door, the post on the mat and, once the door is open, whoever is standing on the step.
Hang it where the door can swing freely beneath it, and make sure its lowest point is no less than 2.1 m (6 ft 11 in) off the floor. In a hall, people walk straight under the light, often carrying shopping or a pushchair.
The switch belongs right beside the door, on the handle side, so you reach it as the door opens and never walk into a dark hall. In England, the government's guidance for assessing hazards in homes, the Housing Health and Safety Rating System, asks for lighting in every hall, stairs and landing that is controllable and accessible, with switches placed conveniently for safe use.
Outside the door is a separate job, with its own heights and IP ratings: see our guide to outdoor lights by the front door.
A second light for a long hall
In a long hall, one light by the door leaves the far end dim. The Pocklington guide adds a second light further from the door to even things out. In a hall with the stairs at the far end, that means one light near the door and one near the foot of the stairs, wired to switch together.
If your hall ceiling is tall enough, a pendant can do this job. Eton is a schoolhouse pendant of milk-white opal glass formed in tiers under a patinated brass collar, hung on a twisted brown fabric flex. Because the opal glows all over, with no brighter spot, it gives an even light without glare. To hang, it needs a ceiling of 2.4 m or more, according to its page; below that, Eton can be fixed flat to the ceiling instead. Of its two sizes, Ø 20 and Ø 30 cm, the smaller is usually plenty in a narrow hall.
Under a low hall ceiling, line up small flush lights instead. Pickering is a little drum of real black marble, just 12 cm wide and 13 cm deep including its metal base. Its page recommends it for older houses with low ceilings, and for landings and corridors where you can fit several in a row. It arrives with an LED bulb, and any standard E27 bulb will fit it later.
Hallway wall lights: light without losing headroom
Where a hall is narrow, wall lights leave the ceiling free and bring the light down to the level of faces and pictures. Set them 1.5 to 1.8 m up the wall, roughly at eye height, so a bright bulb never sits in your line of sight as you go by. Our article on wall light heights explains the range.
The second number to check is depth: how far the light stands off the wall. In a hall about a metre wide, every centimetre that sticks out is a centimetre your shoulder or a bag can catch.
| Light | Fixes to | Made of | Stands out by | Width |
|---|---|---|---|---|
| Haworth | The wall | Opal sphere framed by raised circles | 11 cm | 22 cm |
| Painswick | The wall | Natural stone around a frosted globe | 13 cm | 20 cm |
| Pickering | The ceiling | Black marble | 13 cm overall | 12 cm |
| Eton (small) | The ceiling, hanging or flush | Tiered opal glass | Shade 18 cm tall | 20 cm |
Painswick hides its bulb in a frosted glass globe and sets that globe in a round frame of natural stone. There are seven stones to choose from: the pale ones, such as white jade or travertine, stay quiet on a wall, while the deeper colours become the point of interest in the hall. A pair suits a hall wall well. It is rated IP20, so keep it to dry rooms.
Haworth was made with a period home in mind: an opal glass sphere framed by raised resin circles in an antique white tone. Its small G4 bulb sits behind the glass, so you see the sphere glow, never the bulb. At 11 cm deep it stays close to the wall.
Before you choose a spot, check the wall: you need a wall light point there, and a run of wall free from doors, radiators and the swing of the front door.
Keep the light even between the hall and the rooms
A hall with no window of its own can be far darker than the rooms off it, and every time you walk from one to the other, your eyes have to adjust. The Pocklington guide asks for similar levels of light across the hall and the rooms and stairs that open from it, and suggests that the light in one room should be no more than twice that of the space next to it.
In practice: don't light the hall with a single dim bulb while the sitting room blazes. Keep the same colour of white as the rooms off the hall too, so it doesn't look grey and cold next to a warm room.
Mirrors and console tables
A mirror on the long wall of a narrow hall catches the light from a wall light or the fanlight over the door and sends it back into the space. Hang it where it reflects a shaded light, not a bare bulb, or you will simply see the glare twice.
A console table by the door is where keys, post and gloves end up. A lamp there gives just enough light to find them without switching on the whole hall. Uppingham is 36 cm tall, with an opal glass shade 18 cm across that hides the bulb, so it fits a narrow console. It works by a small pull chain, so stand the lamp with the chain towards the door you walk in by, and one movement turns it on as you go past.
Victorian hallway lighting ideas
Victorian and Edwardian halls often have features worth working with rather than around.
- Ceiling roses. Keep an original plaster rose if you can, and fix the new light into the timber behind it rather than into the moulded plaster.
- Picture rails. They make a natural line on the wall. Keep wall lights below them, at the usual 1.5 to 1.8 m.
- Lath-and-plaster ceilings. Check the weight of any ceiling light, and fix anything substantial into a joist.
- Listed homes. In England, Wales and Scotland, work that would affect the character of a listed building needs listed building consent, so check with your local planning authority before you disturb historic plaster.
For the rest of the house, see lighting a Victorian house, room by room.
A worked example: a terraced house hall
Picture a hall 5 m long and just over a metre wide, with the stairs rising at the far end and two doors off it.
- A ceiling light about a metre inside the front door, clear of the door's swing, with 2.1 m of headroom beneath it.
- A second ceiling light near the foot of the stairs, on the same switch.
- If the ceiling is low, two or three small flush lights in a line instead of pendants.
- A pair of slim wall lights at 1.5 to 1.8 m on the stretch of wall without doors, such as the 11 to 13 cm deep lights above.
- A lamp on the console by the door for evenings.
- All of it in the same warm white as the rooms off the hall.
The stairs and landing come next, with their own safety rules: read our guide to staircase and landing lighting.
Changing a hall light like for like is a job many people do themselves; an electrician can do this for you if you prefer, and our fitting guide lists what to look at first. When you have your measurements, browse our entrance and stair lights. The hall page of our free lighting guide keeps the headroom and wall-light figures on one sheet.


















