
Outdoor Wall Lights for the Front of the House
Outdoor wall lights in the UK should be rated at least IP44, or IP65 where they take the rain. Fix a front-door light so that its centre is roughly 1.8 to 2 m (about 5 ft 11 in to 6 ft 7 in) up from the ground. Choose a warm white, and plan the light around three jobs: finding the door from the street, getting safely up the path, and finding the lock.
What should the light at the front door do?
The Thomas Pocklington Trust's 2018 guide to lighting in and around the home, which the Institution of Lighting Professionals endorses, puts it simply. Outside lighting on the approach to a house is there for three things:
- identifying the front door from a distance;
- getting safely from the road to the door;
- finding the lock and putting the key in.
That means light over or beside the door, on any outside steps, and along the path. The same guide notes that a light which comes on by itself as you approach is helpful and adds to security, and that lighting can show a house is occupied.
How high should an outdoor wall light be?
| Where | Height to the centre of the light | Good to know |
|---|---|---|
| Beside the front door | About 1.8–2 m from the ground | Lights faces on the step and the lock |
| Two lights, one each side of the door | The same 1.8–2 m, both at one height | Measure both from the same level, such as the doorstep |
| Motion-sensor security light | Frequently fitted at 2.4–3 m | Higher, to cover a drive or a side passage |
| Gate pillar | On the face of the pillar, near the top | A short light suits the narrow face |
Think about glare as you choose the height. Pocklington's guide warns that a wall light can dazzle someone walking towards the house, and that a higher mounting lets the beam be angled lower, which helps. A shaded or diffused light at 1.8 to 2 m is kinder than a bare, bright one at eye level.
IP44 or IP65?
Where a porch roof, a canopy or deep eaves keep the wall dry, IP44 is enough: it protects against splashes from any direction. On an open wall that the rain reaches, choose IP65, which stands up to jets of water. Our guide to IP ratings for lights explains both digits.
Among our outdoor lights, Padstow carries IP65, so it can go on an open wall as well as under cover. Truro has a double IP65/IP66 marking, and its page says it suits even an exposed wall. Salcombe is built for outdoor use around a chassis its page describes as hermetically sealed; it doesn't quote an IP code, so ask us if you need one for a particular wall.
Choosing a size for your front
Outdoor lights tend to look smaller on a house wall than they did on screen. Before you order, outline the size on the wall and judge it from the pavement.
Salcombe is a black fluted column, 16 cm wide, in heights of 60, 75, 100 or 120 cm. Its page suggests comparing it with the height of the nearest door or window: the 60 and 75 cm fit a small stretch of wall, while the 100 and 120 cm need a large bare wall, such as the space between two windows. It is made to fix beside a French window, a garage door or on a courtyard wall.
Truro is a slim upright bar, 8 cm across, in ten lengths from 30 to 240 cm, for beside a gate, a garage door or along an outside staircase. To choose, its page suggests a strip of masking tape on the wall at the length you have in mind, then a few steps back.
Padstow is a slim black bar that mounts vertically or horizontally. The shortest length, 30 cm, suits a pillar; the longer ones run under the eaves or a pergola.
Which white by the front door?
Warm white suits the front of a house and the hall behind it. It is also kinder to wildlife: government guidance on light pollution notes that white light with more blue content is generally more disruptive to wildlife than yellower light. Our article on garden lighting without light pollution goes further.
- Salcombe: you choose warm 3000 K, neutral 4000 K or cool 6000 K when you order, and it can't be changed afterwards. For a front door, pick the warm.
- Padstow: four choices of light, from cool white and warm white to a dimmable version and RGB colour. By the front door, take the warm white.
- Truro: its white adjusts anywhere between 3000 K and 6000 K from the remote handset, and an RGB mode adds colour. Set it at the warm end for every day.
Sensors, dusk-to-dawn and switches
Motion sensors light the path when someone walks up to the house, then let it go dark again after a short while. They are common on outside security lighting, and they mean light when you arrive and none when nobody is there. A motion sensor can be added to any version of Padstow: by a garage, the bar comes on as you pull in.
Dusk sensors switch a light on when daylight fades. Some outdoor lights have one built in; none of the three lights above lists one, so for dusk-to-dawn running you would add a separate light-sensitive switch or a timer to the circuit, a job an electrician can do for you. Bear in mind that a light burning all night is the least neighbourly choice. A sensor, or a timer that switches off at bedtime, is kinder to the street and to wildlife.
Ordinary switches still work well. Salcombe runs from an ordinary wall switch and is not dimmable; Truro's colour and white are set from its remote handset.
The house number, the steps and the path
A light by the door is wasted if nobody can read the number. Fix the number where the light falls on it, or the light where it shows the number, so visitors and delivery drivers can find you after dark.
Steps deserve as much light as the door. Pocklington's guide stresses lights on any outside steps and along the path, and suggests a lit post or bollard at the front as a landmark. Truro, fixed upright beside an outside staircase, is one way to light a flight of steps from the side.
Fitting outdoor lights: the rules
Fixed outdoor lighting comes under Part P of the Building Regulations. In England, a new circuit for outdoor lights is notifiable work. Replacing an existing outside light, or adding one to an existing circuit, is not, though the work must still meet BS 7671. In Wales, a new outdoor light point is notifiable too. Scotland and Northern Ireland run separate systems of building control.
Where work is notifiable, either a registered electrician (a member of a government-approved competent person scheme) certifies it, or you apply to building control before you start. Planning permission is a separate question: the Planning Portal says that minor domestic light fittings are not subject to planning controls, but that you should make sure the intensity and direction of the light don't disturb others. For a listed home, the Planning Portal adds that significant works need listed building consent: check with your council's planning team before you drill into a historic front.
Doing it yourself? Isolate the circuit at the consumer unit, confirm with a two-pole voltage tester that nothing is live, and seal the cable entry the way the light's instructions describe. An electrician can do this for you if you prefer. Our fitting guide walks through the checks, and Part P explained covers notifiable work in more detail.
Measure first
- The height of the door, and the wall space on each side of it.
- Where the existing light point or cable comes out of the wall.
- Whether the spot stays dry after a wet, windy day.
- Where the house number sits, and how many steps lead up to the door.
Outdoor heights and IP ratings sit alongside every indoor measurement in The Room-by-Room Lighting Guide, which you can download free.


















