Skip to content

We'll ring you back

Leave your number and a time that suits you: we'll call to talk through your project or a light.

We only use your number to call you back. See our privacy policy.

Basket

Your basket is empty

Article: How Many Lumens Do You Need? A Room-by-Room Guide

A bottle-green Georgian study lined with books, a ceramic pendant lit over a mahogany writing table, sash window at blue hour

How Many Lumens Do You Need? A Room-by-Room Guide

How many lumens for a living room? A useful starting point is the floor area in square metres multiplied by 100 to 300. A sitting room of 4 × 3.6 m (14.4 m²) comes out at roughly 1,450 to 4,300 lumens in total, shared between several lights rather than one. That 100–300 is the floor lighting level, in lux, that the Thomas Pocklington Trust's 2018 lighting guide suggests for most rooms, and the same sum works for every room in the house.

Lumens, watts and lux in one minute

Lumens (lm) measure how much light a bulb gives out. Watts (W) measure how much electricity it uses. With old filament bulbs the two went together, so we learnt to shop by watts. With LEDs they don't, which is why packaging now gives brightness in lumens.

Lux measures how much of that light lands on a surface. One lux is one lumen spread over one square metre. That is the link between the two: lux tells you what a room needs, lumens tell you what to buy.

How many lumens is a 60 watt bulb?

About 806 lumens. The equivalences are fixed by regulation: under the light source labelling rules that apply in Great Britain, a "60 W equivalent" claim on a box corresponds to 806 lumens.

Old filament bulb LED equivalent
15 W 136 lm
25 W 249 lm
40 W 470 lm
60 W 806 lm
75 W 1,055 lm
100 W 1,521 lm
150 W 2,452 lm

Built-in LED lights show why watts mislead. Hexham, a travertine bowl that sits flat to the ceiling, gives 1,600 lm from 36 W in its 30 cm size: a little more light than an old 100 W bulb, from about a third of the power. Its 43 cm gives 1,800 lm and its 55 cm 2,400 lm, so between the two smaller sizes the light barely changes.

How much light does each room need?

The Thomas Pocklington Trust's guide, Lighting in and around the home (2018), gives suggested levels on the floor of each room. It was written for people with sight loss, and it presents these levels as a starting point to be used with care, not as a rule. Below, its suggestions are turned into lumens for typical British rooms.

Room Suggested lux on the floor Example size Total lumens (area × lux)
Sitting room 100–300 4 × 3.6 m (14.4 m²) 1,440–4,320 lm
Dining room 100–300 3.6 × 3 m (10.8 m²) 1,080–3,240 lm
Kitchen 200–300 3.5 × 3 m (10.5 m²) 2,100–3,150 lm
Bedroom 100–300 3.4 × 3 m (10.2 m²) 1,020–3,060 lm
Bathroom 100–300 2.5 × 2 m (5 m²) 500–1,500 lm
Hall 100–300 4 × 1.1 m (4.4 m²) 440–1,320 lm
Stairs 100–200 on the treads Measure the stair area Area × 100–200

Two more lines from the same guide are worth keeping. It recommends that no room be lit to more than twice the level of the room beside it, which spares your eyes a sudden change between the two. And for reading or writing, it suggests at least 200 lux on the page for someone with sight loss, which a lamp beside the chair gives far more easily than a ceiling light.

Why the sum is only a starting point

Area × lux assumes every lumen reaches the floor. In a real room, shades, walls and ceiling absorb part of the light, so the level on the floor ends up lower than the sum suggests. Lean towards the top of the range when:

  • the walls are dark, or the room faces north (see lighting a dark or north-facing room);
  • the ceiling is high, so the lights are further from where you sit;
  • the eyes in the house are older. The guide notes that the lens of the eye yellows with age and lets less light through.

Spread the lumens over several lights

A single ceiling light can produce all the lumens a room needs and still light it badly: bright under the fitting, dim in the corners. Sharing the same total between several sources gives a more even room, and lets you switch parts of it off in the evening. The three layers, ambient, task and accent, are set out in layered lighting explained.

Take the 14.4 m² sitting room again and aim for about 2,900 lm, the middle of its range:

  • a ceiling light of about 1,200 lm;
  • two wall lights of about 400 lm each;
  • two table lamps with 470 lm bulbs, the old 40 W.

That comes to roughly 2,940 lm, from five points instead of one. Bakewell, a flat walnut-tone ceiling light, shows how the size of the fitting changes the figure: its output ranges from 18 W (1,800 lm) to 36 W (3,600 lm), and the largest, at 50 cm, is the one for a large room. The 30 or 40 cm will do in an entrance hall or a study. You can compare more fittings, with their output where the page gives it, among our ceiling lights.

Outside, you need far less

By a front door or a garage, the aim is to see the step and the lock, not to read a newspaper. Padstow, a slim black outdoor light bar, gives around 226 lumens in its 30 cm single-colour version, a little under an old 25 W bulb. Less light outside is also easier on the neighbours and on wildlife.

Buy for the brightest moment, then dim

Choose enough lumens for the time you need the most light, such as cooking, cleaning or a dark winter afternoon, then bring them down in the evening. For that you need bulbs labelled dimmable, an LED-rated dimmer, and a total bulb wattage that stays inside the dimmer's LED limit. Built-in LEDs vary: Hexham, for instance, doesn't work with a wall dimmer, but one version comes with a remote control that sets its brightness. Our guide to dimming LED lights covers the details.

A quick checklist

  1. Measure the room and work out its floor area in square metres.
  2. Multiply by 100 to 300 (200 to 300 in a kitchen) for a total in lumens.
  3. Share that total between at least three lights at different heights.
  4. Read lumens on every box, not watts: 806 lm is the old 60 W.
  5. Keep one colour temperature per room; our 2700K vs 3000K guide helps you pick it.

The lumens-to-watts table and the other key numbers for every room are on the cheat-sheet page of The Room-by-Room Lighting Guide, free to download.

Read more

A reading corner in a claret Georgian sitting room with white panelling, a bottle-green velvet wing chair under a lit blue-and-white ceramic wall light, sash window at blue hour
Bulbs & Dimming

Dimming LED Lights Without the Flicker

Flicker, buzz or a faint glow when the light is off usually means the bulb, the dimmer or the load is wrong. Three checks to run in order, and what our built-in LED lights can and cannot do.

Read more
A cream and green breakfast room with a dresser of blue-and-white china, an opal schoolhouse pendant lit over a round table with tulips, chequerboard floor and sash window at blue hour
Bulbs & Dimming

2700K vs 3000K: Choosing the Right Warm White

Two warm whites, two different jobs. Which colour temperature suits each room, how CRI fits in, and what to do when a built-in LED has its colour fixed at 3000K.

Read more