Skip to content

We'll ring you back

Leave your number and a time that suits you: we'll call to talk through your project or a light.

We only use your number to call you back. See our privacy policy.

Basket

Your basket is empty

Article: How to Clean Your Lights, Material by Material

An oxblood limewashed study with a black metal hoop wall light with an opal globe lit above a desk, sunlight across the wall

How to Clean Your Lights, Material by Material

To clean a glass light shade, switch the light off, let the bulb cool and, if the shade comes off, wash it by hand in warm water with a drop of washing-up liquid. Rinse it, dry it with a lint-free cloth and leave it upside down until it is completely dry before it goes back. Glass is the easy one. Stone, rattan, fabric and brass each need something different, and alabaster should never get wet at all.

First, make it safe

Cleaning a light is a short job. These three habits keep it a safe one.

  1. Power off, then wait. Unplug a lamp. For a ceiling or wall light, switch off at the wall and give the bulb a few minutes to cool. If you are going to take parts off or wipe anywhere near the lampholder, switch the lighting circuit off at the consumer unit as well: in many homes the ceiling rose can stay live even with the wall switch off.
  2. Keep liquid away from the electrics. Never spray anything straight onto a light. Put the cleaner on the cloth, not the fitting, and keep water out of the lampholder and the ceiling plate.
  3. Stand on something steady. Open the stepladder fully on a firm floor and don't over-reach. Glass and stone are heavier than they look, so ask someone to take the shade from you.

Our fitting guide covers safe working in more detail, including how to switch off and check the power is off.

How to clean a glass light shade

Clear, ribbed, tinted and opal glass all wash the same way. Do it at the sink, on a folded towel, so the glass can't knock against the tap or the bottom of the sink.

  1. Fill the bowl with warm, not hot, water and add a little washing-up liquid.
  2. Wash the shade with a soft sponge or cloth. Use a soft brush, such as a clean make-up brush, for ridges, steps and the rim.
  3. Rinse in clean warm water. Leftover soap is a common cause of streaks.
  4. Dry with a lint-free or microfibre cloth, then stand the shade upside down on a towel until every drop has gone, inside as well as out.

Never put a glass shade in the dishwasher, and skip scouring pads and cream cleaners: they scratch. If the glass doesn't come off, don't force it. With the power off at the consumer unit, wipe it in place with a barely damp microfibre cloth, then dry it straight away.

Frosted glass

Frosted glass has a matt surface that tends to show fingerprints and greasy marks more than clear glass. Wash it as above and dry it well. Avoid anything oily or waxy, and anything abrasive, which can leave a patchy finish on the matt surface.

Opal and ribbed glass

Milky opal glass can look clean when it isn't, so give it a wash once or twice a year anyway. Ribbed and fluted glass catches dust in its grooves: a soft brush does most of the work. There's more on that in our guide to fluted and ribbed glass lights. On Eton, the opal glass is formed in steps under a brass collar, so a soft brush along each step is the quickest way to keep it bright.

How to clean marble, travertine and alabaster lights

With natural stone, the risk comes from the cleaner, not the dust. The rule is short: no acids, very little water, and none at all on alabaster. Travertine and marble are both made largely of calcite, the mineral that acids eat into. Alabaster is softer again and reacts badly to water.

Stone Safe to use Never use
Travertine A soft brush or dry cloth; for a stubborn mark, a cloth only just damp with water (plus a drop of pH-neutral soap if needed), then dry the stone Vinegar, lemon, limescale remover, bleach, cream cleaners, scourers
Marble The same as travertine, with as little water as possible, dried straight away Acids, alkaline cleaners, bleach, abrasives
Alabaster A soft, dry brush or cloth only Water, sprays, washing-up liquid, any cleaner

The advice comes from people who look after old stone for a living. The Society for the Protection of Ancient Buildings (SPAB) warns that on marble, "alkaline cleansers, acids, bleach and abrasives may damage the surface", and that even clean water can cause harm, so it should be kept to a minimum and dried off at once. Travertine, in the British Geological Survey's words, is "a hard, dense variety of tufa", a rock laid down from water rich in calcium carbonate, which is why it gets the same treatment. For alabaster, the Church of England's guidance on church monuments is blunt: alabaster dissolves if exposed to water. It recommends nothing more than dusting with a soft brush.

So on Ludlow, whose ring is real travertine, a dry brush or a barely damp cloth is all you need, and travertine's small natural hollows are part of the stone, not dirt. On Buxton, whose natural alabaster comes as rough-edged plates lit from behind, stick to a soft, dry brush and work gently round the edges. If a mark on any stone won't brush off, don't scrub it. Icon, the Institute of Conservation, advises that solvents and detergents be avoided unless a conservator recommends them, and a stone conservator can tell you what is safe.

For more on living with each stone, read our guides to travertine lighting and alabaster lights, or browse our travertine lights.

Rattan and cane

Woven shades trap dust in every gap. Go over them with a soft, dry paintbrush, or with the vacuum's brush attachment on its lowest setting, starting at the top and working down. Now and then a barely damp cloth is fine, as long as the rattan dries fully afterwards. Keep rattan out of steamy rooms. A large woven pendant such as Hawkshead, 50 cm across and woven by hand, is easiest to dust in place with the power off, rather than taken down. Our article on rattan and woven pendants covers where they are happiest in the house.

How to clean a lampshade in fabric or paper

Keep fabric and paper shades dry. Run a lint roller or a soft clothes brush over a fabric shade, or use the vacuum's brush tool on low, always from the top down so the dust falls away from what you've done. If a mark won't brush off a fabric shade, don't reach for water or a stain remover: email us first. A layered shade such as Hathersage, with three tiers of textured fabric, is best done tier by tier with a soft brush. Paper shades, such as the paper disc of Southwold, need a soft, dry brush and nothing else.

Brass, gold-tone and painted metal

Use a soft, dry cloth. Unless the product page says the brass is unlacquered, treat it as a coated finish and leave metal polish in the cupboard. The Canadian Conservation Institute notes that finishes, patinas and lacquers are often extremely thin and can be damaged by even a small amount of abrasion or chemical cleaning. The same goes for an aged look that is there on purpose: Eton's brass collar has an old patina, and polish would take it away. Matt black and painted metal need nothing more than a dry or barely damp cloth.

Chandeliers and lights with many parts

Take a photo before you touch anything, so you know how it goes back together. Switch off at the consumer unit, set the ladder up beside the light rather than under it, and clean one piece at a time from the top down. Don't spin or pull a chandelier to reach the far side; move the ladder instead. Treat each part by its material: alabaster discs get a dry brush, glass gets a damp cloth and a dry one, and stone gets the gentle treatment above.

How often?

There's no fixed rule. As a rough guide:

  • A light dusting with a soft brush or dry cloth every few weeks keeps most lights looking right.
  • A proper wash of removable glass once or twice a year, or whenever the light starts to look dull.
  • Kitchen lights more often: cooking leaves a greasy film that dust sticks to.
  • Stone and alabaster rarely need more than a dust. Less is better.

A clean shade simply lets more of the light through. If your rooms still feel dim after a good clean, the answer may be the bulb or the plan rather than the dust: our free Room-by-Room Lighting Guide gives the brightness and colour to aim for in each room.

Read more

An oxblood limewashed entrance hall with a staircase, a travertine bar wall light lit above a slim console, sunlight on the wall
Period Homes

Lighting a Victorian House: Room by Room

Victorian houses were planned around a light in the middle of each room, under tall ceilings. How to light a terrace today, from the hall to the back bedroom, with the numbers that matter.

Read more
A deep plum Georgian landing with two shell-shaped glass wall lights lit either side of a gilt landscape above a mahogany chest, staircase to the side, evening
Materials

Fluted, Ribbed and Reeded Glass Lights

Fluted, ribbed and reeded glass bend the light into a soft glow with fine lines of sparkle. What the ridges do, clear versus tinted glass, and four pieces to look at.

Read more