Skip to content

We'll ring you back

Leave your number and a time that suits you: we'll call to talk through your project or a light.

We only use your number to call you back. See our privacy policy.

Basket

Your basket is empty

Article: Travertine Lighting: What It Is and How to Live With It

An oxblood-panelled Georgian drawing room at blue hour with a travertine pendant lit over a small round table beside a bottle-green velvet wing chair, sash window and gilt landscape

Travertine Lighting: What It Is and How to Live With It

A travertine wall light is made from real limestone, so no two are the same: the small holes, the veins and the cream-to-sand colour change from one piece to the next. In a UK home it belongs in dry rooms, such as a sitting room, a hall, a landing or a study, and it needs little care beyond a soft brush. The one firm rule is to keep acids, from vinegar to limescale remover, away from the stone.

What is travertine?

Travertine is a limestone that forms at springs. Hard spring water carries calcium carbonate in solution. When it comes out into the air, it loses carbon dioxide, and the calcium carbonate settles out as rock, layer after layer. The British Geological Survey describes travertine as a hard, dense variety of tufa, the softer, spongier deposit that still builds up around small hard-water springs in places such as Gloucestershire.

Because it builds up in layers, sometimes around moss and plant stems, the rock is full of pores and small hollows. Those are the holes you see on the face of a travertine light. They are not damage: they are how travertine is made.

Why does every travertine light look different?

A block of travertine holds its own pattern of bands, veins and pores. Cut it, and you cut through that pattern at a different point each time. Two lights can differ in colour by a shade or two, and the holes never fall in the same place.

Our product pages say so plainly. The stone in Ludlow has veining that "changes from piece to piece". On Kendal, the pattern of the small holes "is never the same from one disc to the next". Each Malton block "has its own colour and veins". If you have ever worried that a light will not match the photograph, this is the one case where that is the point: yours will differ a little from the picture, and it will be its own.

If you would like to see it in the room before it goes up, hold it against the wall first. A change-of-mind return within our 30-day returns needs the light unused and in its original box, so it pays to decide before anything is fixed.

How does travertine handle light?

Travertine is a dense stone, so the design does the work: the light comes from beneath the stone, from beside it or through glass set on it, and each piece sends it somewhere different.

Light Type Where the light goes Light source Size
Malton Wall light, solid block Down the wall, from beneath the stone Integrated LED 24 or 42 cm long, 6 cm high, 5 cm deep
Ripon Wall light, half-moon Indirect; you turn it up, down or to one side when you fit it G9 bulb, included 20 × 13 cm, 5 cm deep
Ludlow Pendant, stone ring Warm, indirect light Integrated LED, 3,000 K Ø 30 or 40 cm; double 60 cm, triple 100 cm long
Kendal Pendant, stone disc Downwards, from beneath the stone LED housed under the stone, 3,000 K Ø 22.5 or 31 cm; triple over 80 or 100 cm
Dedham Table lamp Through a blown-glass dome on a travertine base Built-in LED, 3,000 K Ø 23 cm, 34 cm tall

A few things are worth knowing before you choose. The LEDs in Ludlow, Kendal and Dedham are built in and cannot be replaced, with a stated life of around 50,000 hours. Ludlow dims if you pair it with a compatible dimmer, bought separately. Ripon takes an ordinary G9 bulb, which comes in the box.

Ludlow, Kendal and Dedham all give 3,000 K warm white. Our guide suggests about 2,700 K for sitting rooms, bedrooms and dining rooms, about 3,000 K for studies and kitchens, and one colour temperature per room. So a 3,000 K travertine light sits naturally in a study or a hall. In a sitting room, pick 3,000 K bulbs for the lamps around it, so every white in the room matches.

Which rooms suit a travertine light?

The stone reads as warm and quiet, so it works where you want calm rather than sparkle. Small rooms suit the wall lights: Malton and Ripon are each sized for a space of 3 to 5 m², such as a dressing room, a cloakroom, a guest bedroom or a study under the eaves. At 5 cm deep, Malton sits almost flush with the wall, which helps in a narrow passage.

The pendants need a little more room. Ludlow is made for a sitting room, a landing or a study, and its double and triple versions line up along a long desk or a sideboard. Kendal hangs above a desk or a hall console. For a bookcase or a desk, Dedham needs no wiring at all: set it down, plug it in and use the switch on its cable. Its base has not been polished, so you see the grain of the stone.

Keep travertine out of the bathroom. Kendal is rated IP20, for dry rooms only, and Ludlow, Malton and Dedham are made for indoor use. Near a bath or shower, zones 1 and 2 need a light rated IPX4 at least.

For a low ceiling, a flush disc does the job better than a pendant. Tetbury is a disc of travertine that fixes against the ceiling; our guide to lighting for low ceilings covers it alongside other options under 2.4 m.

Measure first: a hall and landing in a Victorian terrace

Picture a long, narrow hall with a landing above, a classic Victorian terraced house. Before you order, run through these checks.

  • Wall lights: put a pencil mark between 1.5 and 1.8 m up the wall (between about 4 ft 11 in and 5 ft 11 in). A pair of Malton at that height sends the light down the wall, and at 5 cm deep they stay clear of shoulders and coats.
  • Ceiling height: Kendal asks for a ceiling of at least 2.4 m (about 7 ft 10 in).
  • Headroom: where people walk, the lowest point of a pendant should clear the floor by 2.1 m (6 ft 11 in or so). Over a stairwell, take that measurement from the tread beneath the light, not from the hall floor. Ludlow's cable can be set anywhere up to 150 cm, and the pendant can hang from a ceiling that slopes by as much as 30°.
  • Weight and ceiling: check the weight on the product page, and ask us if it is not given. A pendant fixing should hold at least 5 kg, and on lath and plaster anything substantial goes into a joist or a timber batten.
  • Light point: a wall light needs a cable already coming out of the wall. If there isn't one, that is a new light point.

In England, taking down an old light and putting one of these in its place is not notifiable, though the job still has to meet BS 7671, the national wiring standard. In Wales, a new light point needs notifying in a kitchen, a bathroom or outdoors; Scotland and Northern Ireland run separate systems again. An electrician can do this for you if you prefer. Before anyone starts, run through the checks in our fitting guide.

Looking after travertine

Travertine is mostly calcite, the form of calcium carbonate that fizzes when dilute acid touches it, so anything acidic slowly eats into the surface. The care that follows from this is simple:

  1. Switch the light off and let it cool.
  2. Dust with a soft, dry cloth or brush.
  3. If it needs more, use a cloth barely dampened with water or a little pH-neutral soap, then dry the stone.
  4. Never use vinegar, lemon, limescale remover or cream cleaners, and never spray anything onto the light.
  5. Leave the small hollows alone. They are part of the stone, not dirt to fill or scrub.

Marble asks for much the same care, alabaster for even less water. Our guides to alabaster lights and marble wall lights and pendants explain how each stone differs, and how to clean your lights, material by material covers the glass, metal and fabric parts too.

Ripon, Malton, Ludlow and a few more pieces in this stone are gathered in our travertine lights. And if you are planning a whole room, the heights, sizes and colour temperatures are all on one page of The Room-by-Room Lighting Guide, our free guide.

Read more

A bottle-green bedroom with a mahogany bed, a mustard throw and two alabaster wall lights lit either side, afternoon light
Materials

Alabaster Lights: Why the Glow Is Different

Alabaster is a soft, translucent stone, which is why a light behind it looks so different from any other material. What it is, where you have seen it before, and how to live with it.

Read more
A sage hallway with a gilt mirror over a demilune console lit by a brass picture light, daylight
Fitting & Safety

Wall Lights Without Wiring: Plug-In, Rechargeable and Picture Lights

No wall light point? You can still light a wall. How rechargeable lights, plug-in wall lights and cordless lamps compare on brightness and run time, and what renters can do without drilling.

Read more