
Alabaster Lights: Why the Glow Is Different
An alabaster wall light glows differently from other stone lights because alabaster is translucent: light behind a thin piece passes into it, so the stone itself seems to light up rather than just catching light on its face. In Britain, the word usually means a fine-grained form of gypsum: soft enough to scratch with a fingernail, and dissolved by water. So it belongs in a dry room and is cleaned with a dry brush, nothing more.
Is alabaster a stone?
Yes, a natural one, though the name covers two different materials. The V&A separates them clearly: calcite alabaster, very hard and used in ancient times, and gypsum alabaster, a fine-grained, soft and smooth stone that was much easier to carve.
Gypsum is a calcium sulphate mineral. According to the British Geological Survey, it forms when shallow lagoons holding dissolved calcium sulphate partly evaporate in a hot climate, and it is often used as the ornamental stone known as alabaster. You can see bands of white and pink gypsum in the cliffs at Penarth Head, near Cardiff.
Calcite alabaster is a different stone altogether, made of the same mineral as marble and far harder. Our product pages describe Buxton and Castleton as natural alabaster without naming the mineral, so the care advice further down assumes the softer, more delicate kind. That is the safe choice either way.
Why does alabaster glow?
Two things work together: a very fine grain and translucency. A conservation note from the US National Park Service describes alabaster as a translucent, fine-grained stone that polishes to a deep, glassy sheen, and points out that craftsmen have long made thin-walled vases, lamps and lantern shades from it for exactly that reason. The V&A notes that it was prized for its luminosity.
Compare it with travertine, which is dense and full of small hollows. In our travertine lights, the stone hides the light source and steers where the light falls. With alabaster, the stone becomes part of the light. No two Buxton plates are quite alike, and no two Castleton discs share the same veining.
To get the best from that glow:
- Choose warm white. Our guide suggests around 2,700 K for sitting rooms and bedrooms. Buxton comes with warm white LEDs; Castleton comes in warm white or cool white, so pick warm for a living room or bedroom.
- Put it on its own switch. Buxton is not dimmable, and only the remote-control version of Castleton dims. A separate switch lets you use the alabaster as the soft evening light while the brighter lights stay off.
- Mind the height. Aim for 1.5 to 1.8 m above the floorboards (around 4 ft 11 in up to 5 ft 11 in), around eye level, which keeps glare down.
Buxton and Castleton, side by side
We have two lights in natural alabaster, and they do very different jobs.
| Buxton | Castleton | |
|---|---|---|
| Type | Wall light of 1 to 9 rough-edged plates | Chandelier of 1 to 27 discs, spiralling round a gold frame |
| Light | Warm white LEDs fitted at the back, 7 to 36 W | LED strips built in, 6 to 182 W, rising with the number of discs, in cool or warm white |
| Dimming | Not dimmable | Only the version sold with a remote |
| Size | 13 cm wide, 9 cm deep, 18 cm (one plate) to 78 cm (nine plates) tall | Ø 20 cm (one disc) to 70 cm (27 discs); drop up to 150 cm on the smallest versions, 400 cm on the largest |
| Rooms | Living room, dining room or study wall; dry indoor rooms only | Over a large table or the middle of a bedroom; IP20, dry rooms only |
Buxton grows with the wall. One to three plates are enough above a desk; seven or nine need a tall wall, such as the long wall of a living room. Two of them, one on each side of the chimney breast, frame the fireplace.
Castleton is the bigger statement. Every disc measures 20 cm, and adding discs makes the spiral both wider and taller, so take the height of your ceiling before you settle on a disc count. Over a dining table, our guide suggests a light half to two-thirds of the table's width, hung 60–90 cm above the top. In a 1930s semi with a 3.6 × 3.3 m dining room and a 90 cm wide table, that points to a chandelier of roughly 45–60 cm across, and the room-size rule in our guide lands at about 57 cm. The cable can be shortened on site, so the drop can be set to suit your table.
Where have you seen alabaster before?
Most likely in a church. Between the mid-14th and early 16th centuries, alabaster was carved in England on a large commercial scale, mainly from quarries at Tutbury and Chellaston, near Nottingham. Carved panels went into altarpieces for religious foundations and for merchant families, and hundreds were exported, some as far as Iceland and Santiago de Compostela.
The same stone was used for tombs and effigies in the 14th and 15th centuries. A famous early example is the effigy of Edward II in Gloucester Cathedral, carved in the early 1330s. Many alabasters that stayed in England were destroyed or badly damaged at the Reformation. Next time you see an alabaster figure, look at the faces: carvers usually left them unpainted, because the natural colour of the stone suited skin.
Later buildings use it too. Pink and white Penarth alabaster lines the walls of St Margaret's Church in Roath, Cardiff, and a doorway at Cardiff Castle.
How do you look after alabaster?
Gently, and without water. Alabaster is soft, it stains easily and it dissolves in water, so the care is mostly about what not to do.
- Switch off and let it cool before you touch it.
- Use a soft, dry brush. Conservators prefer a brush to a cloth, because wiping builds static that pulls dust back onto the stone.
- No water, no washing-up liquid, no sprays. Rubbing a mark with a cleaning solution can drive it deeper. If something is spilt on it, let it dry and email us before you try anything.
- Handle it with clean, dry hands, or cotton gloves when you fit it. The oils in your skin can soak in and mark the stone over time.
- Keep it out of steam. Both lights are for dry indoor rooms, so no bathrooms, and avoid a spot right above a kettle or a hob.
- Don't glue a chip yourself. If anything arrives damaged, photograph it and email us within 48 hours of delivery.
Travertine and marble can take a barely damp cloth; alabaster cannot. Our guide to marble wall lights compares the three stones, and our cleaning guide for every material covers the metal and glass parts.
Real alabaster or alabaster effect?
Some lights use glass that only imitates the stone. Among the eleven glass finishes of Fowey, for example, are an alabaster effect and an opal finish. That is glass, not stone, and Fowey is rated IP44 against splashes, which makes it a better choice for a kitchen than real alabaster. If a light is sold as alabaster, check whether the page says natural stone or an effect.
Before it goes up
Buxton is wired to an existing wall light point on UK 230 V mains. No point on that wall yet? In England, a new one taken from an existing circuit only has to be notified when it falls within the zone around a bath or shower. Either way, the wiring has to meet BS 7671. Welsh rules are stricter: adding a light point to a kitchen, to any room with a bath or shower, or outside has to be notified; Scotland and Northern Ireland have separate regimes. Castleton comes in parts to be put together before it goes up. If you would rather not do either job yourself, an electrician can assemble and connect them, and our fitting guide sets out each stage.
Chandeliers bring weight. Check Castleton's weight with us for the number of discs you have in mind. The wiring regulations ask for a pendant fixing that can carry 5 kg or more, and in an older house our guide to lath-and-plaster ceilings and heavier lights explains how to fix into the timber above.
Both pieces sit with our other centrepiece lights. For the sizes, heights and colour temperatures room by room, keep a copy of our free lighting guide to hand while you measure.


















