Skip to content

We'll ring you back

Leave your number and a time that suits you: we'll call to talk through your project or a light.

We only use your number to call you back. See our privacy policy.

Basket

Your basket is empty

Article: Marble Wall Lights and Pendants: A Short Guide

An oxblood limewashed reading corner with a backlit marble disc wall light lit above a navy velvet armchair, sunlight on the wall

Marble Wall Lights and Pendants: A Short Guide

A marble wall light pairs a disc, a ring or a column of natural marble with a hidden light source, so you see lit stone rather than a bulb, and the veins on yours will be its own. Marble is limestone that heat and pressure have made harder and more crystalline. It suits a hall, a landing or either side of a chimney breast, in a Georgian sitting room as much as a new kitchen extension, and it asks for one thing only: keep acids away from it.

Marble, travertine or alabaster?

All three are natural stones, and all three vary from piece to piece. They behave differently with light, water and cleaning products, though.

Marble Travertine Alabaster
What it is Limestone recrystallised by heat and pressure deep underground Limestone laid down by spring water In Britain, usually fine-grained gypsum; a hard calcite kind also exists
What you see Crystalline stone with veins and colour from the original rock Bands, small pores and hollows A very fine, translucent stone
Hardness Harder than the limestone it came from Hard and dense, for a spring deposit Soft enough to scratch with a fingernail
Water and acids Acids attack it; a barely damp cloth is fine Acids attack it; a barely damp cloth is fine Water dissolves it: dry brush only

The short version: marble and travertine are both calcium carbonate, so they share the same weakness for acids and the same easy care. Alabaster is the delicate one. Our guides to travertine lighting and alabaster lights go into each stone in detail.

What do the veins tell you?

A stone mason will call any decorative limestone that takes a polish "marble". A geologist keeps the word for limestone that has been recrystallised, and the British Geological Survey describes marble as a metamorphic rock that started out as a carbonate-rich rock such as limestone. Its colour, minerals and texture depend on what the original rock contained, and coloured marbles come from limestones with impurities in them.

That is why no two lights match. The veins of Richmond mix grey, beige and amber, and their course is never the same twice. Each Bath disc has its own veining too, and our pages say plainly that yours will not look exactly like the photo. If you want a light that matches its neighbour stroke for stroke, choose glass or metal. If you want a light that is yours alone, marble gives you exactly that.

Backlit marble discs

Three of our marble wall lights are discs lit from behind, with the LED out of sight. They differ mainly in size and in the metal detail.

  • Bath pairs a broad marble disc with a ring of metal in a matt gold finish. It measures 22 cm across by 29 cm high, narrow enough for the strip of wall beside a staircase or between two doorways, and its page sizes it for a room of 5 to 10 m².
  • Richmond is a 20 cm disc crossed by a fine metal bar, in gold or black. Its page suggests gold where the room already has brass or warm tones, and black to echo picture frames, handles or other black lights.
  • Beverley has a small metal dome at its centre, in gold or silver, and comes in 20 or 25 cm. The 20 cm stays low-key; the 25 cm can be seen from further away, on a large living-room wall. It is around 8.5 cm deep.

The classic spot for discs like these is a chimney breast, one on each side. For the spacing, read pairing wall lights around a fireplace, mirror or bed.

Marble beyond the disc

Sedbergh stands upright on the wall, with a small marble cylinder, 6 cm across, acting as the shade on a stem of solid copper plated in gold or black. Its light comes out at both ends, up and down. You choose its height, 40, 50, 60 or 80 cm, and whichever you pick, it stands no more than 10 cm off the wall. It is not dimmable, and its page suggests treating it as accent light, in a corridor, on a landing or in a study.

For a marble pendant light, Stamford hangs as a thin marble tube, 8 cm across and 30 cm tall, with one upright slit. The light leaves through that slit alone. It finds room above a sideboard, on a landing or beside a bookcase, and it comes with its ceiling rose and up to 150 cm of cable. On a landing, leave a full 2.1 m (6 ft 11 in, near enough) under its lowest point, measured from the tread below if it hangs over the stairs.

The rest of our marble lights include a marble column and a stone ring round a frosted glass globe. For a low ceiling, Pickering is a small ceiling light in real black marble.

Where marble works in a period home, and in a modern one

In a Georgian or Victorian house, marble has an easy logic. If the room still has a marble fireplace, a pair of discs flanking the chimney breast, set below the picture rail at 1.5 to 1.8 m from the floor (4 ft 11 in–5 ft 11 in, give or take), picks up the stone without copying it. In a narrow hall, Bath fits the strip of wall between two doors, and Sedbergh's shallow depth keeps the passage clear.

In a plain modern room, such as a kitchen extension with black window frames, a single Richmond with a black bar echoes the frames, and Stamford can hang over a sideboard or a side table. Keep marble out of the bathroom, though: Sedbergh and Stamford are for dry indoor rooms, Richmond and Beverley for indoor use, and lights near a bath or shower need IPX4 at least.

Looking after marble

Marble fizzes when a drop of dilute acid touches it, and the Society for the Protection of Ancient Buildings warns that acids, alkaline cleaners, bleach and abrasives can all damage its surface. So the routine is short. Let the light cool after switching it off, then dust the stone with a soft brush or a dry cloth. For a mark that dust won't shift, wipe with a cloth wrung out almost dry, in plain water or with a touch of pH-neutral soap, and dry the stone straight away. Keep vinegar, lemon juice, limescale removers and cream cleaners well away. For the metal and glass parts, see our material-by-material cleaning guide.

Fitting a marble wall light

These lights run on mains power and fix to the wall or the ceiling. Each wall light needs a cable already brought out through the plaster where it will hang; without one, you are adding a new light point. In England, swapping an old light for a new one is not notifiable, and neither is a new point on an existing circuit outside the zone around a bath or shower, but both must follow BS 7671. Wales treats kitchens, bathrooms and outdoor lights more strictly, and Scotland and Northern Ireland set their own rules. An electrician can do this for you if you prefer. Our fitting guide lists what to check first.

Before you choose, measure the wall either side of the chimney breast and the height to the picture rail. The figures that go with them, from wall-light heights to headroom, sit on a single cheat sheet in our free Room-by-Room Lighting Guide.

Read more

An oxblood limewashed library-dining room with two opal schoolhouse pendants lit over a wooden table, bookshelves and sunlight on the wall
Materials

Opal Glass: The Soft-Glow Classic

Opal glass is milky all the way through, so it glows evenly instead of showing a bright bulb. What it is, how the schoolhouse and globe shapes differ, and where an opal light earns its place.

Read more
A bottle-green bedroom with a mahogany bed, a mustard throw and two alabaster wall lights lit either side, afternoon light
Materials

Alabaster Lights: Why the Glow Is Different

Alabaster is a soft, translucent stone, which is why a light behind it looks so different from any other material. What it is, where you have seen it before, and how to live with it.

Read more